Double file re-starts for the 2013 season
RaceCeiver Required, NO other radios or communication equipment or mirrors allowed at any time.
A. BODY RULE: same as super late model.
1. 602 crate engine May run 12 in. spoiler and braces.
A. ALL STEEL NON Crate Engine may run 8″ or 12″ spoiler with a 50lb weight penalty
A .602 crate engine must weigh 2350lbs.
B. ALL STEEL NON Crate engine must weigh 2400lbs.
3. ENGINE RULE:
A. GM CIRCLE TRACK CRATE ENGINE.
B. ALL STEEL ENGINE.
C. P/N 88958602 “602’’
Factory Engine Specifications – NEW
Horsepower 350@ 5000 rpm
Torque 390@ 4000 rpm
Compression Ratio 9.1:1
Block Type Cast Iron
Casting Number See Note Below
Deck Height 9.025(+/-.001”)
Crankshaft Type Cast Iron
Crankshaft Casting Number 14082586
Crankshaft Seal Type 1 piece
Crankshaft Weight 55.3 lbs.
Piston Type Cast Aluminum
Valve Relief Type 4Reliefs
Piston Crown Dished
Piston Weight 594 grams
Connecting Rod Length 5.7”
Connecting Rod Weight 604.15 grams (+/-10.0 grams)
Camshaft Type Hydraulic
Camshaft lift (int/exh@ value) .435”/.460”
Camshaft Lobe Lift (int/exh) .290/.306
Duration @ .050” (int/exh) 212/222
Cam Lobe Centerline 112.5 degrees
Rocker Arm Type Stamped Steel
Rocker Arm Ratio 1.5
Head Gasket Type Composite/Steel
Cylinder Head Type Iron Vortex
Casting Number 12558062
Valve Size int/exh 1.94”/1.50”
Combustion CC’s (+/-1-2 cc) 64
Intake port CC’s (+/-1-2 cc) 170
Exhaust Port CC’s (+/- 1-2 cc) 60
Normal Oil Pressures 40 psi. @ 2000 rpm
NOTE: 602 Engines have casting #’s10243880 OR 14093638
ALL OTHER SPECIFICATIONS REFER TO GM
4. OPTIONAL ENGINE
No hobby motors, 602 Crate engine, or engines built on 602 specs. Vortec heads, 602 camshaft. .030 over bore .020 deck
A. All steel motor
B. Stock straight plug heads(Must have stock valve size)
C. Stock Crankshaft, stock rods, 4 eye brow dishtop pistons
D. Hydraulic camshaft GM 602 only
E Must pull 18 inches of vaccum @ 1400 r.p.m.
A. One four-barrel carburetor only of any manufacture.
B. NO turbo-chargers, blowers or fuel injections.
C. All engines must be naturally aspirated.
D. Two inch carburetor spacer allowed.
A. No electric water pump.
A. NO electric fuel pump.
A. Any HEI factory distributor only.
B. No outside coils or power boxes must bolt in stock position.
A. Engine setback will be 6” inches from center of top ball joint to the most forward spark plug. 1 inch tolerance on engine setback.
B. Engines may be crossed from one manufacturer’s line to another Example: Chevrolet in a Ford, Pontiac, etc.
A. All frames must be of steel construction.
B. Square or rectangular frame must have a minimum of 2” by 2” material, .083-wall thickness.
C. If round tube frame, tubing must have a minimum of 1-3/4” outside diameter, .083 wall thickness.
D. Must run non adjustable steel body shocks, (aluminum body non adjustable shocks allowed must add 25lbs.) no gas or adjustable shocks allowed!
E. $100.00 claim rule on shocks may claim one shock per race.
A. Minimum wheelbase will be 103” inches.
A. All cars must have a suitable steel roll cage protecting the driver’s compartment, including headrest.
B. Side roll bars are mandatory, and must extend into the door panels. A minimum of three (3) bars must be used on the left side.
C. Each bar must be at least 1- ½” in diameter, with a minimum material thickness .083”.
D. Roll cages must be welded to frame.
A. Same as Super Late Model specs.
B. NO mirrors, radios or communication equipment allowed in car at any time.
A. All cars must have 3” inch seat belts with shoulder harness and must be attached to roll cage. And must worn at ALL times.
B. We strongly recommend that all cars have an approved fire extinguisher system, securely mounted, within easy reach of the driver.
C. A 5 lb. Halon System is recommended.
D. All drivers must wear a complete fire suit.
A. Number must be at least 18” inches high and on both sides and top of car.
B. All cars must have a number.
MUFFLERS 25 LBS WIEGHT BRAKE
A. Dirt Pro Muffler or Borla Muffler .
B. NO modifications and/or alterations to mufflers will be allowed.
C. Collector type headers required.
D. All cars must register under 100 decibels.
E. NO deliberate air leaks, vents, holes, etc.
F. Any car that loses a muffler will automatically be disqualified.
A. Four-wheel disc brakes permitted.
B. NO carbon fiber brake parts permitted.
FUEL CELL / FUEL:
A. An approved fuel cell (32 gallon maximum) must be securely mounted in the trunk area of the car, inside a .20 gauge metal box supported by a minimum of two 2” inch by 1/ 8” inch steel straps.
B. All fuel cells must be completely visible from rear of car.
C. Fuel cell must not be mounted lower than bottom of quick-change rear end.
D. Gas only – NO alcohol – NO nitrous oxide, nitro methane or other nitrate additives.
E. NO propylene oxide.
F. Gas must not check above + 5 or – 5 on electronic fuel checker when calibrated with tracks racing gas.
G. Gas must pass acid test.
A. Must have at least one forward and one reverse gear in working order.
B. NO straight drives or in and out boxes.
A. Any brand or type of wheel allowed must be mounted with lug nuts.
B. NO knock-off or center locks wheels.
C. Maximum wheel width – 14” inches.
A. Hoosier 1350, 1600, D-21, D-55, Spec 21 Spec 55, or Crate 21, Crate 55 or American Racer MD 48, 56 or Goodyear G40
B. Tires must have all numbers and name on the tire No grinding off of numbers or names, any tire that has been altered will be illegal.
C. No tire softener, tires will be randomly checked before and / or after race and must punch minimum of 48 (hot or cold) on track durometer.
D. Tires available at the Track (256) 623-RACE (7223)
Any item not listed in protest fees is considered a visual protest item and must be protested before race and not after.
Any crate engine protested must be reassembled and resealed by one of the Authorized Repair/Rebuild Centers.
PENALTIES FOR CRATE ENGINE INFRACTION
Disqualification of race, = 0 points, $0.00 in prize money won during the race, 30-day suspension from Fort Payne Motor Speedway and a $300.00 fine.
The $300.00 fine must be paid before you can return to competition.
Disqualification of race, = 0 points, $0.00 in prize money won during the race and suspension from Fort Payne Motor Speedway for the remainder of the current season.
For questions contract Fort Payne Motor Speedway:
(256) 623- RACE (7223) or
Tim (256) 398-6847, Marvin (706) 346-3385
Track reserves the right to delete, change, or amend rules in the interest of competition
2013 FORT PAYNE MOTOR SPEEDWAY ALL RIGHTS RESERVED.